When I installed PM2000 on OS/2 (Warp4/
FP12) the PMVIEW2000 directory was not appended to the path statement, or anywhere else.
Is this correct?
I ask because I expected it.
I also noticed caution about VFAT
partition. Would this affect install.
(I noticed the VFAT note AFTER I noticed 'missing' config.sys
entries.)

Thanks, jgarren@garrenteed.com

Since most people don't run PMView from the command line, PMView is not added to the path statement. You can add it if you wish to be able to run PMView from the command line.

The VFAT notice is just there in case the installer refuses to start (believe me, you would notice this problem ). If the installer works fine, then you can ignore thir notice.



------------------
Peter Nielsen (peter@pmview.com) "If you can dream it, you can do it" JFK.